User GuideIM 350/430 series

LDAP Authentication

For each user registered in the Address Book, you can register a login user name and login password to be used when accessing an LDAP server.

To use an LDAP server, you need to program it beforehand. For details, see "Programming the LDAP Server", Settings.

Important

  • When [Do not Specify] is selected for LDAP Authentication, the User Name and Password that you have specified in Program / Change / Delete LDAP Server of Administrator Tools settings are applied. For details, see "Programming the LDAP Server", Settings.

  • If User Authentication is specified, contact your administrator.

1Press [Home] (Operation panel screen illustration) at the bottom of the screen in the center.

2Flick the screen to the left, and then press the [Address Book Management] icon.

3Check that [Program / Change] is selected.

4Press the name you want to register or enter the registered number using the number keys.

You can search by the registered name, user code, fax number, folder name, e-mail address, or IP-Fax destination.

5Press [Auth. Info], and then press [Down arrow keyNext].

6Press [Specify Other Auth. Info] under "LDAP Authentication".

7Press [Change] under "Login User Name".

Operation panel screen illustration

8Enter the login user name, and then press [OK].

You can enter up to 128 characters for the user name.

9Press [Change] under "Login Password".

10Enter the password, and then press [OK].

You can enter up to 128 characters for the password.

11Enter the password again to confirm, and then press [OK].

12Press [OK].

13Press [User Tools] (Operation panel screen illustration) on the top right of the screen.

14Press [Home] (Operation panel screen illustration) at the bottom of the screen in the center.