User GuideIM 350/430 series

Directional Magnification (%)

Specify the horizontal and vertical reproduction ratios, individually.

Copies can be reduced or enlarged at different reproduction ratios horizontally and vertically.

Illustration of Directional Magnification

Illustration of horizontal: Horizontal

Illustration of vertical: Vertical

To specify a reproduction ratio, enter the ratio using the number keys or specify the ratio with [Plus] or [Minus].

This section describes how to enter the ratio using the number keys.

1Press [Reduce / Enlarge].

Operation panel screen illustration

2Press [Direct. Mag. %].

Operation panel screen illustration

3Press [Horizontal].

4Enter the desired ratio with the number keys, and then press [Sharp].

Operation panel screen illustration

When specifying the ratio with [Plus] or [Minus], press [Direct. Mag. %], and then press [[Plus][Minus] keys]. Pressing [Plus] or [Minus] after selecting [Horizontal] or [Vertical] changes the ratio in increments of 1%. Pressing and holding down [Plus] or [Minus] changes it in increments of 10%.

5Press [Vertical].

6Enter the desired ratio with the number keys, and then press [Sharp].

7Press [OK] twice.

Note

  • The reproduction ratio is between 25 and 400%.

  • When entering a percentage ratio, you can specify any value in the permitted range, regardless of original or copy paper size. However, depending on settings and other conditions, part of the image may not be copied, or margins will appear on copies.

  • You can select the ratio with priority when [Reduce / Enlarge] is pressed. For details, see Reproduction Ratio.