Installing the Hard Disk

By installing options, you can improve machine performance and expand the available features.

Before beginning work, ground yourself by touching something metal to discharge any static electricity. Static electricity can damage the interface units.
Do not subject the interface units to physical shocks.

Check the contents of the package.

Turn the machine off and unplug the power cord.

Remove the memory cover.

Loosen the screw by using a coin, and then remove the inner cover.

Install the hard disk in the indicated position.

Connect the flat cable and power cord to the hard disk.

Align the upper protrusions on the hard disk into the notches on the machine, and then fasten the hard disk to the machine with the screw.

Connect the flat cable and power cord to the board of the machine.

Insert the two protrusions of the supplied inner cover, and then the lower protrusion, into the notches on the machine.

Tighten the screw.

Attach the memory cover.

Plug in the power cord, and then turn on the machine.

When you switch the power on, a message is displayed indicating that the external hard disk drive will be formatted.

Print the configuration page to confirm the installation.

If it is correctly installed, "Hard Disk" will appear for "Device Connection" on the configuration page.

For details about printing the configuration page, see "List / Test Print", Print.
If the hard disk was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after trying the installation a second time, contact your sales or service representative.
To use the installed hard disk, configure the machine options in "Accessories" in the printer driver. For information about opening "Accessories", see "Configuring Option Settings for the Printer", Driver Installation Guide.