Connecting in Infrastructure Mode
Use infrastructure mode to connect the machine to an access point.
The Wireless LAN interface board must be installed to use Infrastructure mode.
When you use IPv6, set [IPv6] to [Active] in [Effective Protocol] in [Network] of [Host Interface]. IPv6 is inactive as a factory default. When you enable IPv6, a link-local address is automatically set.
When you use IPv6, consult your network administrator.
Press the [Menu] key.
Press the [
] or [
] key to select [Host Interface], and then press the [OK] key.
Press the [] or [] key to select [Network], and then press the [OK] key.
Press the [] or [] key to select [LAN Type], and then press the [OK] key.
Press the [] or [] key to select [Wireless LAN], and then press the [OK] key.
Press the [Escape] key.
Press the [] or [] key to select [Wireless LAN], and then press the [OK] key.
Press the [] or [] key to select [Communication Mode], and then press the [OK] key.
Press the [] or [] key to select [Infrastructure Mode], and then press the [OK]
Press the [] or [] key to select [SSID Setting], and then press the [OK]
Press the selection key beneath [SSID].
Press the selection key beneath [Enter].
Press the [], [], [
] or [
] key to select a character, and then press the [OK] key to enter the SSID that you want to connect to.
Press the selection key beneath [Accept] when you finish entering the SSID.
Press the [] or [] key to select [Security Method], and then press the [OK] key.
Press the [] or [] key to select the security method that is specified for the access point you want to connect to.
Press the selection key beneath [Enter].
Select [WEP] or [WPA2], and then press the selection key beneath [Details] to enter your password.
If you do not use security setting, select [No].
The settings are complete.
To check the connection status, enter [Wireless LAN Signal] in [Wireless LAN] and confirm the signal status.
Obtaining an IP address automatically (IPv4 DHCP)
The machine is set to obtain IP addresses automatically as a factory default.
Press the [Menu] key.
Press the [] or [] key to select [Host Interface], and then press the [OK] key.
Press the [] or [] key to select [Network], and then press the [OK] key.
Press the [] or [] key to select [Machine IPv4 Address], and then press the [OK] key.
Press the [] or [] key to select [Auto-Obtain (DHCP)], and then press the [OK] key.
Specifying an IP address (IPv4)
Press the [Menu] key.
Press the [] or [] key to select [Host Interface], and then press the [OK] key.
Press the [] or [] key to select [Network], and then press the [OK] key.
Press the [] or [] key to select [Machine IPv4 Address], and then press the [OK] key.
Press the [] or [] key to select [Specify], and then press the [OK] key.
Press the selection key beneath [IP Add.], and then enter the IP address.
Press the [OK] key.
Press the selection key beneath [Subnet M], and then enter the subnet mask.
Press the [OK] key.
Press the selection key beneath [Gateway], and then enter the gateway.
Press the [OK] key.
Confirm the [Specify] is selected, and then press the [OK] key.
Press the [Escape] key.