Skip header
 

Installing Applications

The procedure to install applications is described below.

Important

  • If administrator authentication is specified, only the device administrator can install applications. To log in to the machine as the machine administrator, see "Administrator Login Method", Security Guide.

1On the application list screen, select the application you want to install.

Operation panel screen illustration

2Press [Install].

A confirmation message to update the firmware is displayed if the firmware of the machine needs to be updated to install the application. Follow the instructions on the screen. You can apply the update immediately, or specify the time to apply the update. You can change or cancel the specified time later.

3In the confirmation screen, press [Install].

Carefully read the terms of service, if available.

Depending on the application, a product key is required. Contact the sales representative of the application.

A message appears when the installation is completed.

4Press [Close].

Note

  • The contact information of the installed application is displayed on the screen of each application.

  • Depending on the application that is being installed, a message indicating that the application cannot be installed because JavaVM is disabled may be displayed. If this message appears, enable JavaTMPlatform under [Extended Feature Settings] in Web Image Monitor.