Previous
To use this machine as a WSD scanner, you must first configure the following settings using Web Image Monitor on a client computer:
Settings to enable WSD (Pull Type)
WSD protocol (default setting: [Active])
Click [Device Management], click [Configuration], click [IPv4] under [Network], and then enable [WSD (Scanner)].
[Prohibit WSD Scan Command] (default setting: [Prohibit])
Click [Device Management], click [Configuration], click [Initial Settings] under [Scanner], and then set [Prohibit WSD Scan Command] to [Do not Prohibit].
Use the following procedure to enable both WSD (Pull Type).
On the [Start] menu of the client computer, click [File Explorer], and then click [Network].
Right-click the icon for this machine, and then click [View device webpage].
Click [Login].
Enter your login user name and password in the [Login User Name] and [Login Password] boxes respectively, and then click [Login].
Consult your administrator if you require a login user name and password.
On the menu in the left frame, select [Device Management], and then click [Configuration].
Under [Scanner], click [Initial Settings].
Select [WSD] in [Use WSD or DSM].
Set [Prohibit WSD Scan Command] to [Do not Prohibit].
Click [OK].
To use IPv6, set [WSD (Device)] or [WSD (Scanner)] for IPv4 to inactive (disabled).
In an IPv6 environment, only link local addresses can be used for WSD communication.
For details about displaying Web Image Monitor, see "Using Web Image Monitor", Device Management. For details about using Web Image Monitor, see Web Image Monitor Help.
