Copying from the Paper Bypass Location
Use the paper bypass location to copy onto paper sizes that cannot be loaded on the paper input locations.
About how to load paper in the paper bypass location, see User Guide of your device.
If cables are hanging from the back of the machine or objects are near the back of the machine, paper may bump against them and cause a paper jam or wrinkle the paper. Check that there are no objects on the back of the machine before you start copying.
Make sure that [Ready] appears on the copy screen.
Open the front cover, and then pull up the paper holding lever.
Insert the paper copy side up into the paper bypass location.
Lower the paper holding lever, and then close the front cover.
Press [Change Settings] to specify the type of the paper as necessary.
Make sure that the paper bypass location (
) is selected, and then press [
].Press [Paper Size].
Specify the size of the paper, and the press [OK] twice.
Enter the number of copies with the number keys.
Place the original, and start scanning.
Copying starts automatically.
When copying the originals onto two or more sheets of paper, repeat Steps 1 to 6 for as many copies as you are making.When the copy job is finished, press [Reset] to clear the settings.
You can change the paper type and thickness settings in [Paper Size/Paper Type] For details, see User Guide of your device.
If you specify [Display Automatically] for [Paper Settings Screen for Bypass], you can display the [Bypass Paper] screen by pressing [
] instead of pressing []. For details, see User Guide of your device.If the paper bypass location is not automatically selected, press [
].