Specifying the Length of Copy Paper Cut
Specify the length to cut the paper loaded in the paper input location.
You cannot cut the paper in the paper bypass location.
The following paper cut methods are available:
Synchro Cut
Cuts the paper at the same length as the original. If the copy is enlarged or reduced, the machine calculates the appropriate length for the magnification ratio and cuts the paper.
Preset Cut
Cuts the paper at a preset size, regardless of the size of the original. You can use this to copy different sized originals to the same size.
Variable Cut
Cuts the paper to the size entered.
The length of the paper that can be copied depends on your model. If the length you specify exceeds the maximum, the paper will be fed in at a slant, resulting in poor copy quality and wrinkled paper.
When copying originals that are larger than A0 (E), make sure that there is enough ink to finish the job. If the ink runs out while copying, and new ink is added, copying starts from the beginning, not from where it stopped.
When copying originals that are larger than A0 (E) onto two or more sheets of paper, it takes time until the next copy starts.
Cuts the paper at the same length as the original. If the copy is enlarged or reduced, the machine calculates the appropriate length for the magnification ratio and cuts the paper.
Select Paper Input Location 1 or 2.
Make sure that [Synchro Cut] is selected.
Synchro Cut and Format Overlay functions may not be used concurrently.
Depending on the original length and paper type, copy paper length may be different from the original.
Cuts the paper at a preset size, regardless of the size of the original. You can use this to copy different sized originals to the same size.
Select a preset cut size of Paper Input Location 1 or 2.
The preset cut size differs depending on the paper roll width. It is cut in the following sizes.
(mainly Europe)
Paper roll width
Preset
Preset
841 mm
A0
A1
594 mm
A1
A2
420 mm
A2
A3
297 mm
A3
A4
728 mm
B1 JIS
B2 JIS
515 mm
B2 JIS
B3 JIS
364 mm
B3 JIS
B4 JIS
914 mm
1,219 mm
610 mm
880 mm
1,189 mm
594 mm
800 mm
1,189 mm
594 mm
707 mm
1,000 mm
500 mm
680 mm
841 mm
420 mm
660 mm
841 mm
420 mm
625 mm
880 mm
440 mm
620 mm
880 mm
440 mm
490 mm
594 mm
297 mm
440 mm
594 mm
297 mm
(mainly North America)
Engineering
Paper roll width
Preset
Preset
34 inch
34 × 44
22 × 34
22 inch
22 × 34
17 × 22
17 inch
17 × 22
11 × 17
11 inch
11 × 17
81/2 × 11
Architecture
Paper roll width
Preset
Preset
36 inch
36 × 48
24 × 36
30 inch
30 × 42
21 × 30
24 inch
24 × 36
18 × 24
18 inch
18 × 24
12 × 18
12 inch
12 × 18
9 × 12
Others
Paper roll width
Preset
Preset
15 inch
15 × 20
-
14 inch
-
81/2 × 14
Cuts the paper to the size entered.
Select [Variable Cut].
Enter the length with the number keys, and then press [
].
Press [OK].
Select Paper Input Location 1 or 2.