Previous
Solutions vary depending on which color is faint.
If you are not sure which color is affected, perform "(a) Check which color is affected", and then, according to its result, perform "(b) Only black is affected" or "(c) Multiple colors are affected".
(a) Check which color is affected
In [Advanced Settings] for custom paper, select 1217: [Paper Transfer Output Correction: Paper Edge], and then adjust the cursor in [Leading Edge] in [FC] to [
] in steps of 4 to 8 from the present value.
Print the image. Has the problem been resolved?
Yes | Restore the previous settings changed in Step 1, and then perform "(c) Multiple colors are affected". |
No | Restore the previous settings changed in Step 1, and then perform "(b) Only black is affected". |
(b) Only black is affected
In [Advanced Settings] for custom paper, select 1217: [Paper Transfer Output Correction: Paper Edge], and then adjust the cursor in [Leading Edge] in [FC] to [
] in steps of 2 from the present value.
Print the image. Has the problem been resolved?
Yes | Finished! |
No | Go to the next step. |
Is the value in [Leading Edge] changed in Step 1 "-10"?
Yes | <First time> Select 1216: [Paper Transfer Output Correction:Paper Edge:Dflt], and then adjust the cursors in [Leading Edge: DC Mode] and [Leading Edge: AC Mo: DC] in [FC] to [ Next, select 1217: [Paper Transfer Output Correction: Paper Edge], set the value of [Leading Edge] in [FC] to "-2" and then repeat this procedure from Step 1. <Second time and later> This solution cannot apply to resolve this problem. Contact your service representative. |
No | Repeat this procedure from Step 1. |
(c) Multiple colors are affected
In [Advanced Settings] for custom paper, select 1217: [Paper Transfer Output Correction: Paper Edge], and then adjust the cursor in [Leading Edge] in [FC] to [] in steps of 2 from the present value.
Print the image. Has the problem been resolved?
Yes | Finished! |
No | Go to the next step. |
Is the value in [Leading Edge] changed in Step 1 "10"?
Yes | <First time> Select 1216: [Paper Transfer Output Correction:Paper Edge:Dflt], and then adjust the cursors in [Leading Edge: DC Mode] and [Leading Edge: AC Mo: DC] in [FC] to [ Next, select 1217: [Paper Transfer Output Correction: Paper Edge], set the value of [Leading Edge] in [FC] to "2", and then repeat this procedure from Step 1. <Second time and later> This solution cannot apply to resolve this problem. Contact your service representative. |
No | Repeat this procedure from Step 1. |
