Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is resolved.
Procedure 1: Changing process speed
In [Advanced Settings] for the custom paper, set [Process Speed Setting] in 1331: [Motor Speed] to [Low Speed].
Print the image. Has the problem been resolved?
Yes | Finished! |
No | If the problem persists, set [Process Speed Setting] in 1331: [Motor Speed] to [Standard Speed], then proceed to "Procedure 3: Adjusting intervals between sheets". |
Procedure 2: Adjusting intervals between sheets
In [Advanced Settings] for the custom paper, select 1331: [Motor Speed], and then adjust the value in [Paper Feed Interval Setting].
Adjust the length of intervals between sheets to move streaked areas to areas with no print image or intervals between sheets. For instance, when performing black-and-white printing on A3 paper, set this value to 54 percentage points to move the streak to the interval between sheets.