Message |
Cause |
Solution |
---|---|---|
"Please Wait." |
The cable which connects the machine and the external color controller is disconnected. |
Securely connect the machine and external color controller by using the cable. |
"Please Wait." |
This message appears when you press the [Energy Saver] key or the [Check Status] key. |
Wait for a while. If the machine is not ready in 5 minutes, turn off the power and make sure the main power indicator turns off. Wait at least 20 seconds, and then turn on the power again. If the machine is still not ready in 5 minutes, contact your service representative. |
“Please wait.” |
This message appears when the machine is warming up. |
|
“Please wait.” |
This message appears when you change the toner cartridge. |
|
“Please wait.” |
The current environmental condition is outside the recommended temperature range for the machine. |
For details about the optimum environmental conditions for the machine, see Optimum Environmental Conditions After Moving the Machine. |
“Shutting down... Please wait. Main power will be turned off automatically. Maximum waiting time: 11 minute(s)” |
The shut down procedure has begun because the power was turned off while the machine was in standby mode or performing an operation. |
|
“The power cord(s) has been disconnected or the breaker switch is turned off. Turn the main power off, plug in the cord(s) to the wall outlet, and then turn the breaker switch on.” |
|
|