Top Page > Maintenance and Management > Maintenance > Where to Put Your Machine > Optimum Environmental Conditions After Moving the Machine > Power connection
![WARNING](../../web/gen/en-warning.gif)
|
Do not use power cords that are damaged, broken, or modified. Also, do not use power cords that have been trapped under heavy objects, pulled hard, or bent severely. Doing so could result in fire or electric shock.
|
|
Be sure to disconnect the plug from the wall outlet at least once a year and check for the following:
If any of the above conditions exist, do not use the plug and consult your dealer or service representative. Use of the plug could result in fire or electric shock.
|
|
Be sure to disconnect the power cord from the wall outlet at least once a year and check for the following:
The power cord's inner wires are exposed, broken, etc.
The power cord's coating has a crack or dent.
When bending the power cord, the power turns off and on.
Part of the power cord becomes hot.
The power cord is damaged.
If any of the above conditions exist, do not use the power cord and consult your dealer or service representative. Use of the power cord could result in fire or electric shock.
|
![CAUTION](../../web/gen/en-caution.gif)
|
The capacity of power in this machine is 60 A and 9,000 W with both cords combined. Connect each cord to separate power sources with independent breakers. If you connect to an electrical outlet that is connected to the same breaker, the breaker may cut off power.
|
|
When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the cord can damage the power cord. Use of damaged power cords could result in fire or electric shock.
|
Power Source
(mainly Europe and Asia)
220–240 V, 30 A, 50/60 Hz
(mainly North America)
208–240 V, 30 A, 50/60 Hz
Please be sure to connect the power cord to a power source as above.
Voltage tolerance
Voltage must not fluctuate by more than 10%.
This machine uses two power cords. Connect each power plug to separate power sources with independent breakers.