PS Menu

You can specify how long the printer waits (in seconds) before canceling the current job when the job is interrupted while being processed.

Default: [Use Driver / Command]

If you select [Use Machine Setting(s)], enter a value between 0 and 999.

You can specify how long the printer waits (in seconds) before it cancels receiving the job when the printer cannot detect the end of the job.

Default: [Use Driver / Command]

If you select [Use Machine Setting(s)], enter a value between 0 and 999.

You can specify how the source tray will be selected by specifying the default value for DeferredMediaSelection in PostScript.

Default: [Select Paper Tray]

• Auto Select

  The default value for DeferredMediaSelection is "true". The source tray that matches the paper setting specified in a print job will be selected.

• Select Paper Tray

  The default value for DeferredMediaSelection is "false". The source tray will be selected according to the media selection of PostScript Language Reference.

Select which side of paper to print on when the PS command is used to perform two-sided printing, and the "setpagedevice" command is entered.

Default: [Active]

• Active

  Cancels two-sided printing, and prints pages after the "setpagedevice" command has been entered on the front side of paper.

• Inactive

  Retains two-sided printing, and prints pages after the "setpagedevice" command has been entered on the back side of paper.

You can select a data format.

Default: [TBCP]

When operating the machine with a parallel connection, and also if the binary data is sent from the printer driver, the print job is canceled.

When an Ethernet connection is used, the print job is canceled if:

• The printer driver data format is TBCP and the data format selected using the control panel is Binary Data.

• The printer driver data format is binary and the data format selected using the control panel is TBCP.

You can set the print resolution in dots per inch.

Default: [600 dpi (Standard)]

Reduces toner consumption when printing. When this setting is enabled, print quality may be degraded.

Default: [Off]

You can make an RGB setting.

Default: [Super Fine]

You can set the color profile.

Default: [Auto]

Specify the color model.

Default: [Color]

Specify whether or not to automatically detect the print data orientation.

Default: [On]

You can specify how to print black or gray tones.

Default: [Black/Gray by K (Black)]