Skip header
 

Settings that can be configured on the control panel

The print settings for a document stored in the machine can be changed using the "Detailed Settings" screen on the control panel. The following settings can be changed:

Edit tab

  • 2 Sided

    When printing on both sides, specify a binding method.

Finishing tab

  • Sort / Stack

    When printing multiple sets, specify whether to print in batches or ordered sets.

  • Staple

    If an optional finisher is installed, you can specify the staple settings. Note that for stapling, only staple positions can be specified. In addition, if paper is set to be selected automatically, staple positions may not be as expected.

  • Punch

    If an optional finisher is installed, you can specify the punch settings. In addition, if paper is set to be selected automatically, punch positions may not be as expected.

Details tab

  • Toner Saving

    Reduces toner consumption when printing. If this setting is enabled, print quality may lower.

  • Rotate by 180 Degrees

    Specify whether to rotate the print image 180 degrees relative to the paper orientation.

Note