Skip header
 

Staple position

The specified staple position varies depending on paper feed and print data orientation. The following table shows the staple positions:

Paper Orientation on the Machine

Print Data Direction

Staple Position

Finisher SR5050

Booklet Finisher SR5060

Illustration of paper orientation

Portrait

Illustration of staple position

Illustration of staple position

Landscape

Illustration of staple position

Illustration of staple position

Illustration of paper orientation

Portrait

Illustration of staple position

Illustration of staple position

Landscape

Illustration of staple position

Illustration of staple position

Paper Orientation on the Machine

Print Data Direction

Staple Position

Finisher SR5110

Booklet Finisher SR5120

Illustration of paper orientation

Illustration of paper orientation

Portrait

Illustration of staple position

Illustration of staple position

Landscape

Illustration of staple position

Illustration of staple position

Note

  • Stapling might not be in the specified position if combine and two-sided printing are both selected. After setting the staple position, use the printer driver's preview icon to check the position before printing.

  • When center staple is set, the fore edge of prints can be cut using the trimmer. For details about cutting the fore edges of prints, see the printer driver Help.

  • Empty the trimmer tray if prints are ejected with waste paper stuck to them.