Skip header
 

Saving Energy

This machine has the following energy saving functions.

Fusing Unit Off mode

If you do not use the machine for a certain period after an operation, the machine makes a clicking sound and enters Fusing Unit Off mode.

When the machine is in Fusing Unit Off mode, the display is on but the fusing unit heater is off to save energy. In this mode, you can change the machine's settings on the control panel. However, the machine must exit this mode to print.

You can change the amount of time that the machine waits before switching to Fusing Unit Off mode under [Fusing Unit Off Mode (Energy Saving) On/Off]. For details, see "System Settings", Device Management.

To exit Fusing Unit Off mode, start print jobs.

The time required to return from Fusing Unit Off mode and resume printing is as long as the time required for warm-up time. For details about the warm-up time, see "Specifications for the Main Unit", Specifications.

Low Power mode

If you do not use the machine for a certain period after an operation, the display will turn off and the machine goes into Low Power mode. The machine uses less electricity in Low Power mode.

You can change the amount of time that the machine waits before switching to Low Power mode under [Low Power Mode Timer]. For details, see "System Settings", Device Management.

You can change the machine's settings to enter Low Power mode when you press the [Energy Saver] key. For details, see "System Settings", Device Management.

To exit Low Power mode, do one of the following:

  • Press the [Check Status] key

Sleep mode

If the machine remains inactive for a specified period or the [Energy Saver] key is pressed, it enters Sleep mode to further reduce the electricity it consumes. For details, see "System Settings", Device Management.

When the machine is in Sleep mode, only the [Energy Saver] key and the [Check Status] key are usable. The machine can print jobs from computers.

You can change the amount of time that the machine waits before switching to Sleep mode under [Sleep Mode Timer]. For details, see "System Settings", Device Management.

To exit Sleep mode, do one of the following:

  • Press the [Energy Saver] key

  • Press the [Check Status] key

Note

  • When the machine is in Low Power mode, the [Energy Saver] key is lit. In Sleep mode, the [Energy Saver] key flashes slowly. In Fusing Unit Off mode, the [Energy Saver] key is not lit.

  • The energy saving functions will not operate in the following cases:

    • When fixed warm-up is in progress

    • When operations are suspended during printing

    • When a warning message appears (The machine enters Fusing Unit Off mode unless the cover is open.)

    • When paper is jammed (The machine enters Fusing Unit Off mode except when the cover is open.)

    • When the Data In indicator is lit or flashing

  • The machine does not enter Low Power mode or Sleep mode in the following cases:

    • During communication with external equipment

    • When the hard disk is active

    • When the service call message appears

    • When the “Add Toner” message appears

    • When toner is being replenished

    • When one of the following screens is displayed:

      • Machine Features

      • Counter

      • Inquiry

      • Address Book Management

      • Tray Paper Settings

    • When the remote administration service notification screens is displayed.

    • When data is being processed

    • When the Data In indicator is lit or flashing

    • When the sample print, locked print, hold print, or stored print screen is displayed

    • When the screen of a document that was stored under the printer function appears (The machine enters Low Power mode if this happens)

    • When the internal cooling fan is active

    • When accessing the machine using Web Image Monitor