Skip header
 

With an optional finisher and punch unit attached, holes can be punched into printed outputs.

If the PCL 6 printer driver is used, Punch can be specified in the “Punch:” list on the [Frequently Used Settings] tab or in the [Finishing] menu on the [Detailed Settings] tab. If the PCL 5c printer driver is used, it can be specified in the [Setup] tab. For printing methods, see the printer driver Help.

Important

  • For details about the optional units required for this function, see "Functions Requiring Optional Configurations", Device Management.

  • When bidirectional communication is disabled, configure option settings for the machine using the printer driver. If options are not set correctly in the printer driver, you cannot make punch settings even if a finisher with the punch function is installed. For details, see "Configuring Option Settings for the Printer", Printer Driver Installation Guide.

  • Be sure to set the paper size and paper orientation in the printer driver when using this function.

Note

  • For details about the paper size and thickness that can be punched, see "Specifications for Punch Unit (Finisher SR5050, Booklet Finisher SR5060)" or "Specifications for Punch Unit (Finisher SR5110, Booklet Finisher SR5120)", Specifications.