Previous
To protect it from shock and vibration during transit, this machine comes packaged in cushioning foam and secured with tape. Remove the protective materials after placing the machine in the location where it will be installed.
|
|
The removed tape is sticky. Be careful not to let the sticky side touch your skin or clothes.
Do not grip the tray area when lifting the machine.
Make sure that paper clips, staples, or other small metallic objects do not fall inside the machine.
Remove the plastic bag.
Lift the machine with two people by using the inset grips on both sides of the machine.
Lower the machine slowly and carefully to prevent getting your hands stuck.
Be sure two people lift the machine.
When moving the machine, do not hold the following parts. Doing so may cause them to break.
The handle on the standard paper tray
The underside of the bypass tray
ADF
Remove the tape on the outside of the machine.
While pressing and holding the bypass tray open lever in the upper center of the bypass tray, pull the tray open.
Remove the tape.
Close the bypass tray.
Open the ADF, and then remove the protective materials.
Pull the top cover open lever upward to open the top cover.
Remove the cushioning material and print cartridges.
Remove the tape.
Return the print cartridges to its original position.
Close the top cover with both hands carefully.
Remove the protective film from the LCD.
When you have finished unpacking, do the following:
If you want to use the machine with optional accessories installed, see Installing Options.
If you want to use the machine without optional accessories installed, see Loading Paper.
For details about settings up the machine, see Machine Set Up Procedure.
