Forwarding

You must first register the forwarding destination in the Address Book. For details, see "Address Book", Connecting the Machine/System Settings.

You can only specify an e-mail address or a folder as the end receiver.

To register two or more end receivers, use group destination. For the maximum number of destinations you can register in a group, see Maximum Values.

Do not specify a group including G3 destination as the destination for forwarding because doing so prevents memory transmission to all destinations.

Press [Forwarding].

Select [On] or [Off].

If there is an end receiver already programmed, a receiver name is shown. If you want to change the receiver, press [Receiver] and proceed to Step 3.

If you select [Off], proceed to Step 4.

Press [Email] or [Folder] to switch the transmission type.

Specify an end receiver using the destination list, and then press [OK].

Press [OK].

Press [File Type to Transfer].

Select [TIFF] or [PDF].

Press [OK].