When installing multiple options, the following order is recommended:
Attach the lower paper trays or Tray 3 (LCT).
Either the lower paper trays or Tray 3 (LCT) can be attached, but not both.
Attach the large capacity tray (LCT).
The lower paper trays or Tray 3 (LCT) must have been attached.
To attach this option, contact your sales or service representative.
Install the HDD.
Install the HDD on the controller board.
Install the interface board.
Install in the slot of the controller board.
Only one interface board can be installed.
Insert SD card options.
Insert in the SD card slot of the controller board.
There are two slots for SD cards.
Each slot supports different types of SD cards.
If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or service representative.
Attach the bridge unit or the Internal Multi-Folding unit.
Either the bridge unit or the Internal Multi-Folding unit can be attached, but not both.
To attach this option, contact your sales or service representative.
Attach Finisher SR3210 or Finisher SR3230.
Either the Finisher SR3210 or Finisher SR3230 can be attached, but not both.
Either the bridge unit or the Internal Multi-Folding unit and also either the lower paper trays or Tray 3 (LCT) must have been attached.
To attach this option, contact your sales or service representative.
Attach the punch unit to the finisher.
To attach this option, contact your sales or service representative.
Attach the output jogger unit to Finisher SR3230.
To attach this option, contact your sales or service representative.
Attach Mailbox.
To attach this option, contact your sales or service representative.
Attach Attention Light.
To attach this option, contact your sales or service representative.