Skip header
 

Connecting to the Ethernet Interface (Type 1, 2, 5, and 6) (mainly Asia)

This section describes how to connect an Ethernet interface cable to the Ethernet port.

CAUTION

  • Properly shielded and grounded cables and connectors must be used for connections to a host computer (and/or peripheral) in order to meet emission limits.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • When using 100BASE-TX/10BASE-T:

      Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Make sure the main power is switched off.

2Connect the Ethernet interface cable to the Ethernet port.

illustration of connecting Ethernet cable

3Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

4Turn on the main power switch of the machine.

Gigabit Ethernet port illustration (numbered callout illustration)

  1. Indicator (orange)

    When 100BASE-TX is operating, the LED is lit orange.

  2. Indicator (green)

    When 10BASE-T is operating, the LED is lit green.

Note

  • When Energy Saver mode is enabled, the LEDs may not light up.

  • For details about how to turn on the main power switch, see "Turning On/Off the Power", Getting Started.

  • For details about installing the printer driver, see "Installing the Printer Driver", Driver Installation Guide.

PreviousNext