Previous
The paper size setting is changed in the same way for every paper tray.
In the following example procedure, the paper size setting for Tray 2 is changed.
Check the paper edges are aligned at the right side.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
While pressing down the release lever of the side fence, slide the side fences outward.
While pinching the release lever of the end fence, slide the end fence outward.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
Align the end and side fences gently against the paper you loaded.
Make sure that there is no space between the paper and the side fences or end fence.
Carefully slide the paper tray fully in.
After sliding the paper tray in, make sure that the paper size is changed correctly on the [Copy] initial screen. To display the [Copy] initial screen, press [Home] (
), and then press the [Copy] icon.You can load envelopes into Trays 2–4. When loading envelopes, place them in the correct orientation. For details, see Envelopes.
Adjust the supporting side fence before loading into the tray sheets of paper whose size is over A3
or 11 × 17. For details, see Adjusting the supporting side fence.
