Previous
|
Do not turn off the main power switch while the machine is saving data to a memory storage device. Doing so may damage the device. If you turned off the main power switch while data was being saved, be sure to check whether the data in your device was saved correctly.
USB flash memory device and SD cards are supported for direct printing. However, certain types of USB flash memory device and SD cards cannot be used. For details, contact your sales or service representative.
This machine supports FAT16 or FAT32 format USB flash memory device and SD cards. Other forms of memory storage device are not compatible.
This machine does not support the use of external USB hubs or SD card readers.
If a memory storage device is being accessed, do not disconnect it and do not turn off the machine. Doing so can damage the memory device and corrupt its data.
If the machine is turned off or the memory storage device is removed while data is being accessed, check that the data stored on it is not corrupted.
It is possible that any data stored in the memory storage device will be damaged or lost by user error during operation or software error. Be sure to back up of all data beforehand. The manufacturer shall not be liable to you for damages or loss of any data produced by using this function.
If the media access lamp does not light when an SD card is pushed into the media slot, do the following:
Reinsert the SD card.
The SD card may be broken. Contact the shop where you bought it.
