Skip header
 

Programming/Changing Information Boxes

This section describes how to set up an Information Box.

You can store the following items:

You can edit boxes in the same way you program them. However, boxes that are being used cannot be edited.

For details about this function, see Information Boxes.

1Press [Fax Features].

2Press [General Settings].

3Press [Box Setting].

4Check that [Program / Change] is selected.

5Select the box to program.

When programming a new box, press [Not Programmed].

Operation panel screen illustration

To change a box already programmed, press it, and then proceed to Step 8. If a password is programmed, enter the password using the number keys, and then press [OK].

6Press [Information Box].

7Enter a box name, and then press [OK].

8Enter the SEP Code using the number keys.

To change the SEP Code, press [Clear], and then try again. To change the box name, press [Box Name], and then repeat the procedure from Step 7.

9Specify a password as necessary.

Press [Password], enter a password using the number keys, and then press [OK]. Re-enter the password for confirmation, and then press [OK].

10Press [OK].

11Press [Exit] twice.