Previous
The solution depends on whether the area within 90 mm (3.5 inches) of the trailing edge is denser or fainter.
<If the area within 90 mm (3.5 inches) of the trailing edge is fainter>
In [Advanced Settings] for the custom paper in use, check the present value in [Transfer Timing Roller Feed Speed Adj]. Is it the upper limit?
Yes |
Contact your service representative. |
No |
Go to the next step. |
Increase the value in [Transfer Timing Roller Feed Speed Adj] by 0.1 percentage point.
Print the image. Is the problem resolved?
Yes |
Finished! |
No |
Repeat Steps 2 and 3. If the problem persists even though you have increased the value to +1.0%, contact your service representative. |
<If the area within 90 mm (3.5 inches) of the trailing edge is denser>
In [Advanced Settings] for the custom paper in use, check the present value in [Transfer Timing Roller Feed Speed Adj]. Is it the lower limit?
Yes |
Contact your service representative. |
No |
Go to the next step. |
Decrease the value in [Transfer Timing Roller Feed Speed Adj] by 0.1 percentage point.
Print the image. Is the problem resolved?
Yes |
Finished! |
No |
Repeat Steps 2 and 3. If the problem persists even though you have decreased the value to -1.0%, contact your service representative. |
