When loading paper that is 100.0 to 139.2 mm (3.94 to 5.48 inches) in vertical length, attach the postcard side fences.
Open the front cover of the wide LCT, remove the screws from the postcard side fences, and then take them out.
Postcard side fences
Close the front cover.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Fit the indentation on the bottom of the postcard side fence with the limit mark into the head of the screw on the bottom of the inner side fence.
Fit the hole on the top of the postcard side fence into the projection on the top of the side fence.
Set the other postcard side fence to the front side fence in the same way.
Fasten the postcard side fences with the screws.
Align the end fence and side fences with the paper size to be loaded, and then load the paper.
Carefully slide the paper tray fully in.
Replace the postcard side fences after use.