Previous
Use the "spoolsw" command to view and configure the Job Spool settings.
You can only specify diprint, trap, lpr, ipp, ftp, wsprn, and smb (TCP/IP) protocols.
The "spoolsw" command for configuring Job Spool settings is available only when the hard disk is installed.
View settings
The Job Spool setting appears.
msh> spoolsw
Job Spool setting
msh> spoolsw spool {on|off}
Specify "on" to enable Job Spool, or "off" to disable it.
Resetting Job spool setting
msh> spoolsw clear job {on|off}
When the machine power is turned off during job spooling, this determines whether to reprint the spooled job.
Protocol configuration
msh> spoolsw diprint {on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw wsprn {on|off}
