Previous
Select a line port or protocol to be used for standard fax or IP-Fax transmission.
When the extra G3 interface unit is installed, you can connect to a maximum of three ports.
G3
G3 is selected after power up or when the machine is reset. If you install the extra G3 interface unit, you can select [G3-1], [G3-2], [G3-3], or [G3 Auto] depending on the number of the installed unit.
Multi-port
When the extra G3 interface unit is installed, communications can take place simultaneously through three lines at once.
The following list shows protocol combinations available for each line type.
Option |
Available line types |
Available protocol combinations |
|---|---|---|
Without option |
PSTN |
G3 |
Extra G3 interface unit |
PSTN |
G3 |
Extra G3 interface unit |
PSTN |
G3 |
PSTNIP-Fax
When sending an IP-Fax, select either [SIP] or [H.323] as the protocol.
Ask your administrator whether you should select [SIP] or [H.323] as the protocol.
If you use the Address Book to specify a destination, the line settings configured for each destination in the Address Book are applied.
Use this procedure to specify the line manually when you enter a destination directly.
When Using the Fax Application
About how to use the application's screen, see "[Fax] Screen".
When Using the Fax (Classic) Application
For details about how to use the classic fax function, see Procedure for Changing the Line Port (Classic).
