Previous
Check that the paper edges are aligned with the left side.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Release the end fence.
Loosen the screws holding the side fences in position.
Load paper by aligning the paper with the left side of the paper tray.
Push down the bottom plate of the paper tray to the lowest position.
Place paper with print side up.
Load a stack of paper about 5–10 mm (0.2–0.4 inches) high.
Make sure the paper rest on top of the supporting plates on both sides.
Supporting plates
Take the grip of the side fences with your fingers, and adjust the side fences to the paper size.
Set the paper flush against the protrusions on the bottom of the inner side fence and against the surface of the opposite side fence.
Check that the scale numbers on the top of the side fences are roughly the same.
Take the grip of the side fence with your fingers, and adjust the side fence to the paper size.
Fasten the front side fence in the same way.
Load additional sheets, if necessary.
Do not stack paper over the limit mark.
Tightly fit the end fence to the loaded paper, and then re-lock the end fence again.
Make sure there are no gaps between the paper and end fence.
Carefully slide the paper tray fully in.
Before you print on coated paper from the three-tray wide LCT for the first time, contact your service representative.
After sliding the paper tray in, make sure that the paper size is changed correctly on the printer's initial screen. To display the printer's initial screen, press the [Home] key, and then press the [Printer] icon.
You can load envelopes into the three-tray wide LCT. When loading envelopes, place them in the correct orientation. For details, see Envelopes.
