Previous
Banner Paper Guide Tray
Allows you to load large-sized paper in the bypass tray.
Lower paper tray
Paper is loaded here.
Tray 3 (LCT)
Consists of two paper trays.
You can load paper even if Tray 3 (LCT) is in use. It is okay to pull out the left half of the tray while Tray 3 (LCT) is in use.
Large capacity tray (LCT)
Paper is loaded here.
Lower paper trays
Consists of two paper trays.
Bridge unit
Relays paper to the finisher.
Mailbox
Sorts printed paper. Consists of mailbox output trays 1–4.
Internal Multi-fold unit
Internal Multi-fold unit can apply the following folds: Half Fold, Letter Fold-out, Letter Fold-in, and Z-fold.
Finisher SR3210
Sorts, stacks, and staples multiple sheets of paper. Consists of the following paper trays:
Finisher upper tray
Finisher shift tray
Copies can be punched if the optional punch unit is installed on the finisher.
Booklet Finisher SR3220
Sorts, stacks, and staples multiple sheets of paper. The saddle stitch function can staple multiple sheets of paper in the center and fold them into booklets. Consists of the following paper trays:
Finisher upper tray
Finisher shift tray
Finisher booklet tray
Copies can be punched if the optional punch unit is installed on the finisher.
Finisher SR3230
Sorts, stacks, and staples multiple sheets of paper. Consists of the following paper trays:
Finisher upper tray
Finisher shift tray
Copies can be punched if the optional punch unit is installed on the finisher.
Output jogger
Jogs the sheets delivered to the finisher shift tray.
You cannot install multiple finishers simultaneously.
Finisher SR3210, Finisher SR3230, and Booklet Finisher SR3220 can be attached only if the bridge unit and either lower paper trays or Tray 3 (LCT) is installed.
To use the output jogger, Finisher SR3230 is required.
