Specify the horizontal and vertical lengths of the original and copy image.
Copies can be reduced or enlarged at different reproduction ratios horizontally and vertically.
: Horizontal length
: Vertical length
Specify length and width of the originals and the copies.
Press [Reduce / Enlarge].
Press [Dir. Size Mag. mm].
Enter the horizontal size of the original with the number keys, and then press [
].
Enter the horizontal size of the copy with the number keys, and then press [
].
Enter the vertical size of the original with the number keys, and then press [
].
Enter the vertical size of the copy with the number keys, and then press [
].
Press [OK] twice.
The reproduction ratio is between 25 and 400%.
The horizontal and vertical length of an original can be entered in steps of 1 mm. The horizontal length of an original can be 1 to 999 mm; the vertical length of an original can be 1 to 999 mm. The horizontal and vertical length of copies can also be entered in steps of 1 mm. Both the horizontal and vertical length of copies can be 1 to 999 mm.
If the calculated reproduction ratio falls below the minimum reproduction ratio, the calculated reproduction ratio will be adjusted to the minimum ratio. If the reproduction ratio is over the maximum reproduction ratio, it will be adjusted to the maximum ratio. If this happens, with some ratios, parts of the image might not be copied or margins will appear on copies.