Administrator Tools

You can make a test call to the @Remote center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Notify Machine Status] or [Remote Diagnostics] is in use.

You can send notification of the printer's status to the @Remote center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Service Test Call] or [Remote Diagnostics] is in use.

You can send a request to repair the printer to the service center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Service Test Call] or [Notify Machine Status] is in use.

You can display the firmware version of the printer.

Specifies whether the same printer driver can be used for multiple printers or not under USB connection.

Default: [Off]

• On

  The same printer driver you have installed in your computer can be used with any printer other than the one originally used for installation, if the printer is of the same model.

• Off

  You must install the printer driver separately for individual printers, because the printer other than the original will be recognized as a new device upon USB connection.

You can reset the printer settings to their factory defaults. Be sure to turn off and then on the main power of the printer to make the setting effective.

• Reset All Settings

  You can reset all printer settings to their factory defaults.

• Reset Network Settings

  You can reset the network settings of the printer to their factory defaults.

You can specify the time zone by entering the time difference between your local time zone and Coordinated Universal Time (UTC). You can enter a value between -1440 and +1440 minutes.

You can specify whether or not to restrict the control panel operation by setting a password. Even if this feature is enabled, it is not necessary to enter the password when printing from a computer or clearing errors.

For details, see Security Guide.

Default: [Off]

• On

• Off

When [Ready State After Printing] is set to [Cntrl Panel Off (EngySavg)], you can specify whether or not the printer resumes Sleep mode immediately after exiting Energy Saver mode.

Default: [Immediate]

• Immediate

  The printer resumes Sleep mode immediately after printing, regardless of the Sleep Mode Timer settings.

• After Time Set by Tmr Ends

  The printer resumes Sleep mode after the time specified in Sleep mode elapses.

You can specify how the printer operates when it receives print jobs in Sleep mode.

Default: [Cntrl Panel Off (EngySavg)]

• Control Panel On

  The printer turns on the control panel and prints received jobs.

• Cntrl Panel Off (EngySavg)

  The printer prints received jobs but the control panel remains off.