Previous
Sizes of paper that can be fed from the bypass tray are as follows:
When the banner paper guide tray is installed:
Horizontal length: 139.7–1260.0 mm (5.50–49.60 inches), vertical length: 90.0–330.2 mm (3.55–13.00 inches)
When the banner paper guide tray is not installed:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 90.0–330.2 mm (3.55–13.00 inches)
Note however that the limitation on the horizontal and vertical length range will vary depending on which options are installed.
When prints are delivered to the upper tray or the shift tray of Finisher SR4120 or Booklet Finisher SR4130:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 90.0–330.2 mm (3.55–13.00 inches)
When prints are delivered to the upper tray of Finisher SR4110:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 100.0–330.2 mm (3.94–13.00 inches)
When prints are delivered to the shift tray of Finisher SR4110:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 139.0–330.2 mm (5.48–13.00 inches)
Load the paper face up in the bypass tray.
The bypass tray (
) is automatically selected.
Press [
].
Press [Paper Size].
Press [Custom Size].
Enter the horizontal size with the number keys, and then press [].
Enter the vertical size with the number keys, and then press [].
Press [OK] twice.
Place the originals, and then press [Start].
You can register a custom paper size. For details, see Procedure for registering a custom size (classic). You can also recall the registered custom paper size. For details, see Procedure for recalling the registered custom size (classic).
