Top Page > Operating Instructions > Configuring and Managing the Printer > Printer Configuration Items List > System Settings > Interface Settings

Interface Settings

Previous Next

Network
Machine IPv4 Address	Auto-Obtain (DHCP) (default)
	Specify	MAC Address Machine IPv4 Address 11.22.33.44 (default) Subnet Mask 0.0.0.0 (default)
IPv4 Gateway Address
Machine IPv6 Address	Link-local Address, Manual Configuration Address, DHCPv6 Address, Stateless Address: 1-5
IPv6 Gateway Address
IPv6 Stateless Address Autoconfiguration	Active (default), Inactive
DHCPv6 Configuration	Active	Operation Mode Router Request (default) Obtain IP Address Do not obtain IP Address DNS Server Address Auto-Obtain (DHCPv6) (default) Specify
	Inactive (default)
DNS Configuration	Auto-Obtain (DHCP) (default)	DNS Server 3 0.0.0.0 (default)
	Specify	DNS Server 1-3 0.0.0.0 (default)
DDNS Configuration	Active (default), Inactive
IPsec	Active, Inactive (default)
Domain Name	Auto-Obtain (DHCP) (default)
	Specify	Domain Name
WINS Configuration	On (default)	Primary WINS Server 0.0.0.0 (default) Secondary WINS Server 0.0.0.0 (default) Scope ID
	Off
Effective Protocol	IPv4	Active (default), Inactive
	IPv6	Active, Inactive (default)
	SMB	Active (default), Inactive
	@Remote Service	Active (default), Inactive
	Firmware Update (IPv4)	Active (default), Inactive
	Firmware Update (IPv6)	Active (default), Inactive
SMB Computer Name
SMB Work Group
Ethernet Speed	AutoSelct:Enable 1Gbps, AutoSelct:Disable 1Gbps (default), 10Mbps Half Duplex, 10Mbps Full Duplex, 100Mbps Half Duplex, 100Mbps Full Duplex
LAN Type	Ethernet (default), Wireless LAN
Ping Command
Permit SNMPv3 Communication	Encryption Only, Encryption/Cleartext (default)
Permit SSL/TLS Communication	Ciphertext Only, Ciphertext Priority (default), Ciphertext/Cleartext
Host Name
Machine Name
IEEE 802.1X Authentication for Ethernet	Active, Inactive (default)
Restore IEEE 802.1X Authentication to Defaults
USB Speed	Auto Select (default), Full Speed

[LAN Type] is displayed only when the optional Wireless LAN interface board is installed.

Parallel Interface
Parallel Timing	ACK inside, ACK Outside (default), STB down
Parallel Communication Speed	High Speed (default), Standard
Selection Signal Status	High (default), Low
Input Prime	Active, Inactive (default)
Bidirectional Communication	On (default), Off
Signal Control	Job Acceptance Priority (default), Printer Priority

This menu appears only when the optional IEEE 1284 interface board is installed.

Wireless LAN
Communication Mode	802.11 Ad-hoc Mode, Infrastructure Mode (default), Direct Connection: Group Owner Mode, Direct Connection Mode
SSID Setting
Ad-hoc Channel	1-11 (default), 36, 40, 44, 48
Security Method	Off (default)
	WEP	WEP (Encryption) Key
	WPA2	WPA2 Authent. Method WPA2, WPA2-PSK
Wireless LAN: Easy Setup / Direct Connection	Push Button (default), Enrollee
Wireless LAN Signal
Restore Factory Defaults
Direct Connection Settings

This menu appears only when the optional wireless LAN interface board is installed.

Print List
Print List