Skip header
 

Simultaneous Storage and Sending by E-mail

1Press [Store File].

Operation panel screen illustration

2Make sure that [Store to HDD plus Send] is selected.

3If necessary, specify the stored file's information, such as [User Name], [File Name], [Password], and [Select Folder].

  • User Name

    Press [User Name], and then select a user name. To specify an unregistered user name, press [Manual Entry], and then enter the name. After specifying a user name, press [OK].

  • File Name

    Press [File Name], enter a file name, and then press [OK].

  • Password

    Press [Password], enter a password, and then press [OK]. Re-enter the password for confirmation, and then press [OK].

  • Select Folder

    Press [Select Folder], specify the folder in which to save the stored files, and then press [OK].

4Press [OK].

5To send an e-mail, make other necessary settings such as specifying the destination.

For details about sending a file by e-mail, see Basic Procedure for Sending Scan Files by E-mail.

6Press [Start].

Note

  • You can resend stored files by e-mail. To resend stored files, select the files on the [Select Stored File] screen, and then send them. For details, see Sending a Stored File.

  • If a file is sent and stored simultaneously with [Security] set, the e-mail will be encrypted and the signature applied, but the stored file will be neither encrypted nor signed. For details about encrypting stored files, see "Managing Stored File", Security Guide.