Skip header
 

LDAP authentication

For each user registered to the Address Book, you can register a login user name and login password to be used when accessing an LDAP server.

To use an LDAP server, you need to program it beforehand. For details, see Configuring the LDAP Server.

Important

  • When [Do not Specify] is selected for [LDAP Authentication], the User Name and Password that you have specified in [Program/Change LDAP Server] of [Administrator Tools] settings are applied. For details, see page Configuring the LDAP Server.

  • If User Authentication is specified, contact your administrator.

1Press the [User Tools] key, and then display the screen for changing information about the Address Book.

[Address Book Mangmnt] [Change]

2Select the user for which you want to set up LDAP Authentication.

[All Users] or [User Code] Press the name key of the user

You can search a user by the registered name.

You can also specify a user by pressing [Reg. No.] and entering the registered number.

3Set up LDAP Authentication for the selected user.

[Auth. Info] [LDAP Authentication] [Specify Other Auth. Info] Press [Change] under "Login User Name" Enter the login user name [OK] Press [Change] under "Login Password" Enter the password [OK] Enter the password again to confirm [OK]

Note

PreviousNext