Previous
Replacement Alert
You can specify when the Alert Indicator lights up to prompt users to replace the print cartridge
Default: [Normal]
Notify Sooner
Normal
Notify Later
Display Supply Info
You can specify whether or not the amount of toner is displayed on the initial screen.
Default: [On]
On
Off
Menu Protect
You can specify whether or not to protect the menu settings. If you enable this setting, you must specify a protection level.
If you want to lower the protection level, disable this setting or select [Level 1].
You may not be able to change this setting depending on the setting of the printer.
Default: [Level 2]
Level 1
Level 2
Off
List/Test Print Lock
You can specify whether or not to prohibit List/Test printing.
You may not be able to change this setting depending on the setting of the printer.
Default: [Off]
On
Off
Paper Size Error Detect
You can specify whether or not to detect paper size errors.
Default: [Detect]
Detect
When a print job is being performed, the printer checks if the size of the paper fed from the tray matches the size specified on the [Paper Input] menu, paper size dial in the tray, or in the printer driver. If an error is detected, an error message is displayed and printing stops.
Do not Detect
The printer does not detect paper size errors.
When [Paper Size Error Detect] is set to [Detect], form feed cannot be performed.
Unit of Measure
You can switch the unit of measurement between [mm] and [inch].
Default:
(mainly Europe and Asia)
[mm]
(mainly North America)
[inch]
mm
inch
Panel Key Sound
You can specify whether or not to enable the panel key sound.
Default: [On]
On
Off
Display Contrast
You can specify the display density by selecting one of seven levels.
Key Repeat
You can specify whether or not to scroll the display panel when the [
] or [
] key is held down. When you enable this setting, specify the scroll speed. (If repeat time is set to "Long", scroll speed becomes slow.)
Default: [Normal]
Do not Repeat
Normal
Repeat Time: Medium
Repeat Time: Long
Tray Parameters (PCL)
You can configure settings to change paper tray parameters used for PCL printing. You can specify the settings for the installed trays and the Auto Tray Select function.
Auto Select
Tray 1
Tray 2
Bypass Tray
Tray Parameters (PS)
You can configure settings to change paper tray parameters used for PostScript printing. You can specify the settings for the installed trays only.
Tray 1
Tray 2
Bypass Tray
