Skip header
 

Connecting to the USB Device Server

This section explains how to connect an Ethernet interface cable to the USB device server.

The network interface cable connected to the USB device server must use a ferrite core to prevent RF interference.

Important

  • Be sure to turn off the power switch of the printer before connecting or disconnecting the Ethernet interface cable.

1Make a loop at a distance of a few centimeters (1) from each end of the Ethernet interface cable, and then attach to each loop the ferrite core provided with the USB device server.

Ethernet interface cable illustration

2Connect one end of the Ethernet interface cable to the Ethernet port of the USB device server.

Illustration of connecting the ethernet interface cable

You can use either a straight or crossover Ethernet cable for connecting to the USB device server.

3Connect the other end of the cable to the Ethernet port of the computer to be used for setup.

After setup is complete, connect this end of the Ethernet cable to a network device, such as a hub.

4Connect the power plug of the printer to the wall outlet and turn the printer on.

It may take several seconds for the printer to recognize the USB device server. If you have disconnected the USB cable, connect the USB cable again.

LED indications

If the USB device server is attached properly, the LEDs on the Ethernet port light up as follows:

Gigabit Ethernet port illustration

During 100BASE-TX operation, the upper LED lights up in yellow.

Gigabit Ethernet port illustration

During 10BASE-T operation, the lower LED lights up in green.

Gigabit Ethernet port illustration

During 1000BASE-T operation, both LEDs light up.