Skip header
 

Connecting to the Gigabit Ethernet Interface

This section explains how to connect an Ethernet interface cable to the Gigabit Ethernet port.

Important

  • If the main power switch is on, turn it off.

  • Use the Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more.

1Make sure the power is switched off.

2Remove the cable cover.

Rear side of the printer illustration

3Connect the Ethernet interface cable to the Gigabit Ethernet port.

Rear side of the printer illustration

4Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

5Turn on the main power switch of the printer.

Check the network indicator.

Gigabit Ethernet port

When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating or the printer is not connected to a network, it is turned off.

Gigabit Ethernet port

When 100BASE-TX is operating, the LED is lit orange. When 10BASE-T is operating or the printer is not connected to a network, it is turned off.

Gigabit Ethernet port

When 1000BASE-T is operating, both LEDs are lit.

The LEDs turn off when the Ethernet cable is disconnected or the printer is in Sleep Mode.

6Attach the cable cover.

Rear side of the printer illustration

Note

  • Use an Ethernet interface cable that supports the speed that you selected for "Ethernet Speed". If you select [Auto Select: Enable 1Gbps] for "Ethernet Speed", use an Ethernet interface cable that supports 1000BASE-T. For details, Setting Ethernet Speed.

  • Check the type of the plug before connecting.

  • Do not pull the connected cable forcefully. Make sure the cable is properly connected. Otherwise, it might become disconnected or somebody might trip on it.

  • Using a cable with some connectors or converters may result in an improper connection.