Top Page > Operating Instructions > Setting Up the Printer > Connecting the Power Cord
|
Do not use power cords that are damaged, broken, or modified. Also, do not use power cords that have been trapped under heavy objects, pulled hard, or bent severely. Doing so could result in fire or electric shock.
|
|
Be sure to disconnect the plug from the wall outlet at least once a year and check for the following:
If any of the above conditions exist, do not use the plug and consult your dealer or service representative. Use of the plug could result in fire or electric shock.
|
|
Be sure to disconnect the power cord from the wall outlet at least once a year and check for the following:
The power cord's inner wires are exposed, broken, etc.
The power cord's coating has a crack or dent.
When bending the power cord, the power turns off and on.
Part of the power cord becomes hot.
The power cord is damaged.
If any of the above conditions exist, do not use the power cord and consult your dealer or service representative. Use of the power cord could result in fire or electric shock.
|
|
When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the cord can damage the power cord. Use of damaged power cords could result in fire or electric shock.
|
Do not turn off the main power switch immediately after turning it on. Doing so may result in damage to the hard disk or memory, leading to a malfunction.
Do not turn off the main power switch until the printer has finished starting up. Doing so may result in a malfunction.