Skip header
 

Procedure for Scanning Multiple Pages of Originals as One File (Classic)

1Press [Original Feed Type].

Operation panel screen illustration

2Press [Batch] or [SADF].

To scan originals using the exposure glass, select [Batch]. To scan originals using the ADF, select [SADF]. For detail about [Batch] and [SADF], see Batch , SADF.

3Press [OK].

4Place originals.

5Make settings for sending or storing.

6Press [Start] to scan originals.

If [Batch] is selected, place additional originals, and then press the [Start].

If [SADF] is selected, scanning starts automatically when you place additional originals. Place subsequent originals after the originals have been scanned.

Repeat this step until all originals are scanned.

7After all originals are scanned, press [Sharp] as necessary.

Storing or transmission starts.

Note

  • If [Batch] is selected, originals can be scanned using the ADF.

  • When scanning originals using the exposure glass, depending on the settings for [Wait Time for Next Orig.: Exposure Glass] under [Scanner Features], the machine can wait for additional originals even if [Batch] is not selected in [Original Feed Type]. For details about [Wait Time for Next Orig.: Exposure Glass], see Scan Settings.

  • If, under [Scanner Features], [Set Wait Time] is set for [Wait Time for Next Orig.: Exposure Glass] or [Wait Time for Next Original(s): SADF], place additional originals within the specified time. When the countdown ends, transmission or storage starts automatically. To start transmission or storage before the countdown is completed, press [Sharp]. Countdown is canceled if Scan Settings or other settings are changed in the meantime. Place additional originals, and then press [Start]. The machine scans the originals and the countdown is resumed. For details about [Wait Time for Next Orig.: Exposure Glass] and [Wait Time for Next Original(s): SADF], see Scan Settings.

  • If [SADF] is selected, scanning from the exposure glass is enabled after scanning from the ADF. If this happens, you must press [Start] to start scanning.