Skip header
 

This section explains the [Erase Border] and [Reduce / Enlarge] settings of the [Edit] tab in [Scan Settings].

[Erase Border]

Deletes the borders of the scanned original according to the specified width.

If you select [Same Width], you can specify a uniform width for deletion all around the original (top, bottom, left, and right sides). If you select [Different Width], you can specify a different width for deletion for each side.

[Reduce / Enlarge]

When scanning a bundle of mixed size originals, you can unify the size of the scanned data by using [Specify Size].

Entering values in the Reduce / Enlarge configuration screen

Operation panel screen illustration numbered callout illustration

  1. Specify Reproduction Ratio

    Enter a value for the reproduction ratio.

    To make a small adjustment to the reproduction ratio value, press [plus] or [minus].

    To make a large change to the value, enter the desired value using [Number keys], and then press [Sharp].

    To use a pre-defined reproduction ratio, press the desired ratio.

  2. Specify Size

    Specify the finished size of the scanned originals.

    Press [Specify Size], and then specify the finished size of the scanned originals.

    To select [Custom Size] for the finished size of the scanned originals, enter the value of [Short Edge] and [Long Edge] of the scan size using the number keys.

Note

  • [High Compression PDF] cannot be selected if the [Reduce / Enlarge] function is used.

  • For details about how to edit the pre-defined reproduction ratio, see Scan Settings.

  • Region B icon(mainly North America)
    [Reduce / Enlarge] cannot be specified if [LT/LG Mixed Sizes] is used.