Skip header
 

Placing originals

The following table shows the relationship between the original orientation and the Scanner Properties dialog box settings:

Exposure glass

Original orientation

TWAIN Scanner Control dialog box key

Top edge touches top left of exposure glass

Illustration of the original orientation

This orientation is the TWAIN driver's standard setting. Place originals in this orientation normally.

Driver screen illustration

Top edge touches rear of exposure glass

Illustration of the original orientation

Driver screen illustration

Bottom edge touches left side of exposure glass

Illustration of the original orientation

Driver screen illustration

Bottom edge touches top of exposure glass

Illustration of the original orientation

Driver screen illustration

ADF

Original orientation

TWAIN Scanner Control dialog box key

Top edge of original placed first

Illustration of the original orientation

Driver screen illustration

Top edge touches rear of ADF

Illustration of the original orientation

Driver screen illustration

Bottom edge touches left side of ADF

Illustration of the original orientation

Driver screen illustration

Bottom edge touches top of ADF

Illustration of the original orientation

Driver screen illustration

Note

  • Originals are normally vertically long (Illustration of an original) or horizontally long (Illustration of an original). However, the table above uses squares to make original orientation easier to understand. Even if the actual shape of the original is different, the combination of original orientation and the orientation specified on the scanner driver does not change.

  • For details about the Scanner Control dialog box, see the TWAIN driver Help.

  • Depending on the settings, originals of different sizes are scanned differently.