Skip header
 

Procedure for Changing the Line Port (Classic)

1Press [Select Line].

Operation panel screen illustration

2Select the line you want to use.

Operation panel screen illustration

The following lines and protocols are displayed according to the machine's configuration:

  • Only standard G3

    G3

  • When one optional extra G3 unit is installed

    G3-1, G3-2, G3 Auto

  • When two optional extra G3 units are installed

    G3-1, G3-2, G3-3, G3 Auto

  • When H.323/SIP are set to "On"

    G3, H.323, SIP

If you select "G3 Auto", the machine will use any available line. This increases efficiency.

3Press [OK].

Note

  • A maximum of three simultaneous communications are possible. You cannot perform three Immediate Transmissions simultaneously.

  • If three communications are in progress, the display shows the first communication that was initiated.

PreviousNext