Skip header
 

Procedure for Erase Border (classic)

Erases the edge margin of the original image.

There are two types in the Erase Border mode.

1Press [Edit / Stamp].

Operation panel screen illustration

2Press [Erase].

3Press [Erase Center / Border].

4Make sure that [Erase Border] is selected.

5Select [Same Width] or [Different Width].

6Specify an erase border width with [Plus] and [Minus].

If [Same Width] is selected in Step 5:

Operation panel screen illustration

If [Different Width] is selected in Step 5:

Operation panel screen illustration

Press the key that you want to change, and then specify a new value.

7Press [OK] twice.

Note

  • Pressing [Plus] or [Minus] changes the width in increments of 1 mm (0.1 inches). Pressing and holding down the relevant key changes the width in increments of 10 mm (1 inch).