Previous
|
Do not subject the card to physical shocks.
Turn the printer off and unplug the power cord.
Open the rear cover.
Unhook the tab on the interface cover, which is located on the side of the rear cover.
Unhook the two tabs on the outside of the interface cover.
Insert the SD card into the slot until it clicks.
If you insert only one SD card, use the upper slot. If you insert two SD cards simultaneously, use both slots. If you insert the optional VM card, use only the lower slot.
If you want to use two or more SD cards simultaneously, contact your service representative.
Hook the two tabs on the outside of the interface cover.
Hook the tab on the interface cover, which is located on the side of the rear cover.
Close the rear cover.
Plug in the power cord, and then turn on the printer.
Check that the SD card was installed correctly.
You can confirm that the SD card was installed correctly by checking the control panel menu or configuration page.
VM card: Make sure [JavaTM/X] appears when the [Switch Functions] key is pressed.
XPS card: Printing the configuration page, if the XPS card is installed properly, "XPS" will appear for "Printer Language" in "System Reference". For details about printing the configuration page, see Test Printing.
If the card is not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after trying the installation a second time, contact your sales or service representative.
Do not touch the card while the printer is in use. It may come loose, even if pushed only slightly. The slot cover must be reattached.
