Skip header
 

Unpacking

To protect it from shock and vibration during transit, this printer comes packaged in cushioning foam and secured with tape. Remove the protective materials after placing the printer in the location where it will be installed.

WARNING

  • The following explains the warning messages on the plastic bag used in this product's packaging.

    • Keep the polythene materials (bags, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.

CAUTION

  • The printer weighs approximately 18 kg (40 lb.).

  • When moving the machine, use the inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.

Important

  • The removed tape is sticky. Be careful not to let the sticky side touch your skin or clothes.

  • Do not grip the tray area when lifting the printer.

  • Make sure that paper clips, staples, or other small metallic objects do not fall inside the printer.

1Remove the plastic bag.

2Take the power cord and waste toner bottle out of the box in which the printer was packed.

3Lift the printer using the inset grips on both sides of the printer.

Lower the printer slowly and carefully to prevent getting your hands stuck.

When moving the printer, do not touch the following parts:

  • Convex parts on the right side of the machine

  • Places indicated on the labels attached to the machine

  • The bottom of the optional paper tray

4Remove the adhesive tape attached on the machine's exterior.

When you have finished unpacking, do the following:

  • If you want to use the printer with optional accessories installed, see Installing Options.

  • If you want to use the printer without optional accessories installed, see Loading Paper.

For details about settings up the printer, see Printer Set Up Procedure.

PreviousNext