Skip header
 

Placing originals

The following tables show the relationship between the original orientation and the Scanner Control dialog box settings:

Exposure glass

Original orientation

TWAIN Scanner Control dialog box key

Top edge touches left side of the exposure glass

Illustration of the original orientation

This orientation is the TWAIN driver's standard setting. Place originals in this orientation normally.

Driver screen illustration

Top edge touches rear of the exposure glass

Illustration of the original orientation

Driver screen illustration

Bottom edge touches left side of the exposure glass

Illustration of the original orientation

Driver screen illustration

Bottom edge touches top of the exposure glass

Illustration of the original orientation

Driver screen illustration

ADF

Original orientation

TWAIN Scanner Control dialog box key

Top edge touches left side of the ADF

Illustration of the original orientation

Driver screen illustration

Top edge touches rear of the ADF

Illustration of the original orientation

Driver screen illustration

Bottom edge touches left side of the ADF

Illustration of the original orientation

Driver screen illustration

Bottom edge touches top of the ADF

Illustration of the original orientation

Driver screen illustration

Note

  • Originals are normally vertically long (Illustration of an original) or horizontally long (Illustration of an original). However, the table above uses squares to make original orientation easier to understand. Even if the actual shape of the original is different, the combination of original orientation and the orientation specified on the scanner driver does not change.

  • For details about the Scanner Control dialog box, see the TWAIN driver Help.