Skip header
 

Placing Originals on the Exposure Glass

CAUTION


  • Keep your hands away from the hinges and exposure glass when lowering the ADF. Not doing so may result in an injury if your hands or fingers are pinched.

Important

  • Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.

1Lift the ADF.

2Place the original face down on the exposure glass. The original should be aligned to the rear left corner.

Start with the first page to be scanned.

Exposure glass illustration numbered callout illustration

  1. Positioning mark

3Lower the ADF.

Note

  • When you place a thick book or three-dimensional original on the exposure glass and lower the ADF, the back side of the ADF rises up to accommodate the original. Keep your hands away from the hinges at the back of the ADF when you close it.

    ADF illustration

  • Take care to place originals after any correction fluid and ink has completely dried. Not taking this precaution could cause marks on the exposure glass that will be scanned.

  • The machine cannot detect the size of the original automatically. Specify the original size. For details about how to specify the size of the originals, see "Specifying Original Sizes", Copy/ Document Server, "Scan Size", Fax, or "Specifying Scan Settings", Scan.

  • For details about the sizes of originals that can be used, see Recommended Original Sizes and Weights.

Related topics

Left original beeper