This section describes the user tools in the [Scan Settings] tab under [Scanner Features].
Next Original Wait Setting
When scanning multiple pages into a single file, you can select [Continuous Wait], [Off], or [Set Wait Time] as the standby mode for the additional originals.
If you press [Next Original Wait] when scanning originals, the machine waits indefinitely for additional originals, regardless of any other settings.
If you do not press [Next Original Wait], the settings you configure here determine the machine's performance as follows:
Continuous Wait
The machine waits indefinitely for additional originals and [Next Original Wait] does not appear.
Off
The machine does not wait for additional originals and sends the scan file immediately.
Set Wait Time
The machine waits for additional originals until the pre-specified wait period (3–999) elapses.
Default: [Set Wait Time], 60 second(s)
Background Density of ADS (Full Color)
Characteristics due to the type of paper such as nonwhiteness like newspaper or transparent originals can be reduced by correcting the scanning density.
Default: The default setting is the middle of 5 adjustment levels.
Reproduction Ratio
Specify magnification ratios displayed in [Specify Reproduction Ratio] on the [Reduce / Enlarge] screen.
(mainly Europe)
25.0% (A0 A4)
35.4% (A1 A4, A0 A3)
50.0% (A2 A4, A1 A3)
70.7% (A3 A4, A1 A2)
141.4% (A4 A3, A2 A1)
200.0% (A4 A2, A3 A1)
282.8% (A4 A1, A3 A0)
400.0% (A4 A0)
User Reduce/Enlarge Ratio (25.0–400.0%)
(mainly North America)
Engineering
25.0% (34 × 44 81/2 × 11)
32.4%
50.0% (17 × 22 81/2 × 11)
64.7%
129.4%
200.0% (81/2 × 11 17 × 22)
258.8%
400.0% (81/2 × 11 34 × 44)
Architecture
25.0% (36 × 48 9 × 12)
33.3%
50.0% (24 × 36 12 × 18)
66.7%
133.3%
200.0% (12 × 18 24 × 36)
266.7%
400.0% (9 × 12 36 × 48)
User Reduce/Enlarge Ratio (25.0–400.0%)
Magnification Key Display(mainly North America)
Specify which reproduction ratio is shown, Engineering or Architecture.
The selected reproduction ratio is shown on the scanner screen and in the [Reproduction Ratio] setting under [Scanner Features].
Default: [Engineering]
Program / Change / Delete Scan Size
You can register, change, or delete the original scan size settings to be used in [Scan Size].
The settings configured here will be displayed in [Scan Size].
Up to 5 settings can be registered.
Default for "Scan Size 1": Not Programmed
Default for "Scan Size 2": Not Programmed
Default for "Scan Size 3": Not Programmed
Default for "Scan Size 4": Not Programmed
Default for "Scan Size 5": Not Programmed
For details about how to change the Scanner Features, see "Accessing User Tools", Connecting the Machine/ System Settings.